Quality wood products from around the world.
InterGlobal Forest Overview
High-density MDF board with a hard, fine and smoothly sanded surface. The board is subject to minimal expansion and swelling in conditions of high humidity.
MDF Fibralux MR NAF has low formaldehyde emission (E1 class). Moreover, MDF Fibralux MR NAF meets the requirements set by the California Air Resource Board (CARB - phase 2). According to ASTM E 1333-96, formaldehyde emission is less than 0,11 ppm, which corresponds to CARB, phase 2 as set by the ACTM.
Upon request, this MDF board can be supplied with PEFC, FSC or FSC Controlled Wood certificate.
Please contact sales for further details and minimum order quantities.
| Sizes (ft) | Max width 8' 4.4", Max length 20' 8" |
| Thickness (in) | 15/64 to 13/16 |
| Finish | Can be lacquered or finished with paper, foil, melamine, veneer or high pressure laminate |
| Class | Type MDF.HLS according to EN 622-5 |
| Certs |
|
MDF Fibralux MR NAF is suitable for interior decoration, industrial processing, and furniture production. The board can be lacquered or finished with paper, foil, melamine, veneer or high pressure laminate. MDF Fibralux MR NAF can also be used for load-bearing applications in humid conditions.
The board can be applied in service class 2 (restrictions in temperature and ambient humidity) and can be used in biological hazard classes 1 and 2 of EN 3353. During and especially after installation the boards must, wherever possible, be optimally protected from any direct contact with water. They must be stacked flat, on a pallet or using a sufficient number of cross members. Boards should not be stored vertically, unless ground contact can be avoided. The board will expand/shrink under variable humidity conditions, albeit to a lesser extent than MDF Fibralux, meaning that an expansion space must be provided for at all times.
Use suitable sawing, milling and drilling tools. MDF Fibralux MR NAF can be used for structural walls, with a restriction in the load duration class. In service class 2, corrosion resistant fittings must be used, e.g., galvanised steel. Nails or screws should be kept at least 8 mm away from the edge of the board.